KT 30A Square Wave
High-power KT square wave controller for 1000-1500W e-bike conversions. 12-FET design with 36V/48V operation. Square wave commutation delivers slightly more startup torque than sine wave at the cost of noise and efficiency. Programmable via KT-series displays.
In brief: 24–48V controller. 17A continuous. 30A peak. Square Wave, dual mode support. From $97.
Type
- VESC Based
- No
Electrical
- Voltage Range
- 24–48V
- Continuous Amps
- 17A
- Peak Amps
- 30A
Motor Features
- Regen Support
- No
- Drive Mode
- Square Wave
- Sensor Mode
- Dual Mode
- Field Weakening
- No
- Self-Learning
- No
- Dual Motor Support
- No
- Controller Pairing
- No
Inputs
- Throttle Support
- Yes
- PAS Support
- Yes
Display
- Supports Display
- Yes
- Requires Display
- No
- Protocols
- KT (Kunteng)
Power Switch
- Supports Power Switch
- No
- Requires Power Switch
- No
- Requires Pre-charge
- No
Programming
- Via Display
- Yes
- Via Phone
- No
- Via PC
- No
Physical
- Weight
- 650 g
- Dimensions (L×W×H)
- 195.0mm × 85.0mm × 44.0mm
Ports & Connectors
Battery Input
Power
1Battery +
2Battery -
Hall Sensor
Hall SensorTemperature
15V Power
2Ground
3Hall A
4Hall B
5Hall C
6Motor Temp
Display
UARTDisplay
1Battery +
2Ground
3UART RX
4UART TX
5High Beam
Throttle
Throttle
15V Power
2Ground
3Throttle Signal
PAS
PAS
15V Power
2Ground
3PAS Signal
Brake
Brake
1Ground
2Brake Signal (Low)
Where to Find
Prices tracked across 1 seller* Some seller links on this page are affiliate links. If you purchase through them, WattWorks may earn a small commission at no extra cost to you. Affiliate status does not influence which products appear, how they are ranked, or the prices shown. Learn more here
