Fardriver ND-Series Function Harness (Gen 1)
Function harness for Fardriver Gen 1 ND-series controllers (open-lug housings F2/F3/F4). 29-pin internal connector breaks out to individual signal connectors: hall sensor (6-pin), throttle (3-pin), speed/LIN display (2-pin), programming (4-pin), alarm/anti-theft (5-pin), 3-speed/reverse (5-pin), brake high (1-wire), and brake low (2-wire). ONE-LIN protocol only — no CAN support on Gen 1.
In brief: Wire harness. From $20.
Where to Find
Prices tracked across 2 sellers* Shipping estimates are for the contiguous US and may vary by location.
* This page contains affiliate links. WattWorks may earn a commission at no extra cost to you. Learn more
Specifications
No specifications available
Ports & Connectors
Hall Sensor
TemperatureHall Sensor
15V Power
2Motor Temp
3Ground
4Hall C
5Hall B
6Hall A
E-Key Lock1 wire
Power Switch
1E-Lock / Ignition
Display (ONE-LIN)
Display
1One-Wire Comm
High/Low Speed
Display
1Gear High
2Ground
3Gear Low
Backward Gear
Display
1Reverse Signal
2Ground
Cruise/BOOST
BrakeDisplay
1Parking / E-Brake
2Gear Sport
Throttle
Throttle
1Ground
2Throttle Signal
35V Power
Brake (High 12V)
Brake
1Brake Signal (High)
Brake (Low 0V)
Brake
1Ground
2Brake Signal (Low)
Speed Pulse
Speed Sensor
1Speed Signal
Programming Port
UART
15V Power
2UART RX
3UART TX
4Ground
Alarm Power
security
1Ground
2Alarm Power
Anti-theft
security
1Anti-Theft Key
2Anti-Theft Signal
3Wheel Signal
Main Connector
