FLIPSKY FT85BS V2.0
The Flipsky FT85BS V2.0 is an updated Non-VESC, FOC-mode ESC rated at 84V / 60A continuous (voltage-derated: 50V/60A, 75V/50A, 84V/40A). Configured via Flipsky ESC Tool (NOT VESC Tool) over USB. Supports Hall-sensored and sensorless (IPDS/HFPI) motor startup, with an integrated red power button and CAN/UART communication ports. Suitable for e-bikes, e-scooters, e-skateboards, and electric motorcycles up to 20S.
In brief: 14–84V controller. 60A continuous. 250A peak. Sinewave, dual mode, regen support. From $52 across 2 sellers.
Where to Find
Prices tracked across 1 seller* Shipping estimates are for the contiguous US and may vary by location.
* This page contains affiliate links. WattWorks may earn a commission at no extra cost to you. Learn more
Specifications
Type
- VESC Based
- No
- Cooling
- Air
Electrical
- Voltage Range
- 14–84V
- Continuous Amps
- 60A
- Peak Amps
- 250A
Motor Features
- Regen Support
- Yes
- Drive Mode
- Sinewave
- Sensor Mode
- Dual Mode
- Field Weakening
- No
- Self-Learning
- No
- Dual Motor Support
- No
- Controller Pairing
- No
Inputs
- Throttle Support
- Yes
- PAS Support
- No
Display
- Supports Display
- No
- Requires Display
- No
- Protocols
- FTESC (Flipsky Non-VESC)
Power Switch
- Supports Power Switch
- Yes
- Requires Power Switch
- No
- Requires Pre-charge
- Yes
Programming
- Via Display
- No
- Via Phone
- No
- Via PC
- Yes
Physical
- Weight
- 500 g
- Dimensions (L×W×H)
- 110.5mm × 55mm × 30mm
Ports & Connectors
Battery Input2 wires
Power
1Battery +
2Battery -
Motor Phases3 wires
Motor Phase
1Phase A
2Phase B
3Phase C
HALL
TemperatureHall Sensor
15V Power
2Motor Temp
3Hall A
4Hall B
5Hall C
6Ground
Power Switch/
Power Switch
1Ground
2Power Switch Signal
3Battery +
ADC5-pin SPECIAL 5 Wires (Genderless)
ThrottleBrakePAS
13.3V Power
2Ground
3Throttle Signal
4Brake Signal (Low)
5PAS Signal
PPM
PPM / Servo
1Ground
25V Power
3PPM Signal
UART4-pin SPECIAL 4 Wires (Genderless)
UART
15V Power
2Ground
3UART TX
4UART RX
CAN2 wires
CAN Bus
1CAN High
2CAN Low
USB
